- Shop safelyShop safely and securely with us
- Fast deliveriesThe delivery time is usually 3-5 business days unless otherwise stated for the product
- Secure paymentsWe offer payments via card, invoice, and Swish.
- Free shippingFree shipping over 1000 SEK
DESCRIPTION
Highsider Can-Bus Resistor CBW1 With Dip-switch.
Our Newly Developed Highsider Can-Bus Resistor CBW1 Fits Most Vehicles That Have a Can-Bus System.
The CBW1 Resistor Provides A Required Electrical Load for Your Vehicle, Which, if the dip switches are set correctly, will result in no flashing of the accessory flashlers in the cockpit.
In addition, a reliability is given. This Means:
If the Accessory Indicators Fail Due to an Electronic Fault, an Error Message is immedialy displayed in the cockpit.
Up to 2 Channels Can Be Operated, Such as Turn Signals at the Rear Left and Turn Signals at the Rear Right.
IF 2 Pairs of Indicators Need to Be Changed, Also 2 CBW1 Needed to Be Used.
Which Requirements Should Be Met In order to use the cbw1 on the motorbike:
The Motorbike was original produced with LED Indicators or the Motorbike has a can-bus system
If these requires are not met, the cbw1 unit will not function (!) In this case, we recommend the following resistances:
For Indicators With 21 Watt:
6.8 Ohm Partnumber 1108546002 or 10 ohm partnumber 1108546004
For Indicators with 10 watts:
27 Ohm Partnumber 1107562
The Following Resistance Values Can Be Set On The CBW1:
- 150 ohms
- 170 ohms
- 240 ohms
- 300 ohms
- 400 ohms
- 600 ohms
- 1200 ohms
Dimensions:
Height = 11mm
Width = 31mm (Without Straps)
Width = 46mm (with tabs)
Length = 40mm
Cable Length = 200mm With Pins
Connections:
Yellow = Input Channel 1 (+)
Orange = Output Channel 1 (+)
Blue = Input Channel 2 (+)
Red = Output Channel 2 (+)
Gray = Input Mass (-)
Black = Output Ground (-)
Hints:
- Up to 2 Channels Can Be Operated.
- The Connection is Explained precious in the mounting instructions!